# Tungsten carbide coating reduces erosion in oil and gas frac sleeves

- Link: https://www.directorstalkinterviews.com/tungsten-carbide-coating-reduces-erosion-in-oil-and-gas-frac-sleeves/4121270015
- Published: 2026-11-18T13:22:00+00:00
- Author: Amilia Stone

Frac sleeves used in oil and gas operations are exposed to high-velocity fluids 
containing sand and ceramic proppant. These materials can quickly wear down internal
surfaces, particularly around ports, ball seats and changes in bore diameter.

Conventional surface treatments can struggle to protect frac sleeves from this type
of erosion.

Gas nitriding hardens only the surface of the steel. Once this hardened layer wears
away, the softer material underneath becomes exposed. Hard chrome plating can also
deteriorate under repeated particle impact, while applying it evenly inside deep
bores can be difficult.

HVOF thermal spray coatings provide a hard surface but can be difficult to apply
consistently inside complex components. The metallic binder within these coatings
can also wear faster than the carbide particles, weakening the coating over time.

Chemical vapour deposition (CVD) tungsten carbide offers an alternative. The process
creates a dense coating that can cover internal bores, ports and other areas that
are difficult to reach using conventional coating methods.

The coating combines hardness with resistance to repeated particle impact. This 
is important because a coating must withstand both abrasion and impact to protect
components operating in demanding downhole conditions.

Testing cited by Hardide found that its Hardide-T CVD tungsten carbide coating experienced
seven times less erosion than HVOF 85WC-10Co-4Cr and 125 times less erosion than
stainless steel under ASTM G76-95 testing conditions.

_**Hardide plc** (LON:HDD) is a pioneer in advanced tungsten/tungsten carbide CVD
coatings. They showcase unmatched capabilities to greatly extend the life of complex
geometry components facing extreme wear, erosion and corrosion._

Share on:
