# Quadrise Fuels International Publication of bioMSAR™ Test Results

- Link: https://www.directorstalkinterviews.com/quadrise-fuels-international-publication-of-biomsar%e2%84%a2-test-results/4121020254
- Published: 2021-09-01T07:36:39+01:00
- Author: Giles

**Quadrise Fuels International plc** ([LON:QFI](https://www.directorstalkinterviews.com/company/quadrise-fuels-international-plc/qfi.l)),
the supplier of MSAR® and bioMSAR™ emulsion technology and fuels, which are low-
cost, cleaner alternatives to heavy fuel oil and biofuels, has reported that test
results of bioMSAR™ on a medium speed 4-stroke Wärtsilä diesel engine at the VTT
facility in Finland, confirming the results announced by the Company on 11 August
2021 when compared to conventional liquid fuels, are now available at: [https://www.quadrisefuels.com/biomsar/references/](https://www.quadrisefuels.com/biomsar/references/).

**bioMSAR™ Test Highlights:**

•    Engine efficiency was higher (up to 7%) than with marine diesel, increasing
with engine load.

•    Average calculated CO_(2) emissions were 26% lower than diesel on a life-cycle(“
well-to-wake”) basis, due to a combination of the 40% renewable glycerine content
of bioMSAR™ and the higher engine efficiency.

•    NOx emissions were lower than for prior HFO and MSAR® tests, and comparable
to diesel, with further NOx optimisation possible.

•    Smoke and particulate levels were very low, as were unburned hydrocarbons emissions,
due to efficient fuel combustion.

•    The existing diesel engine fuel pumps and injectors worked well with bioMSAR
™.

The bioMSAR™ test utilised 5 tons of bioMSAR™ manufactured at the Quadrise Research
Facility, formulated with the intention of achieving a 20% CO_(2) reduction and 
the results presented are in comparison to diesel at 75% load, which is a typical
operating regime for a marine 4-stroke diesel (testing range of 50% to 90% load).

**Further bioMSAR™ Testing at Aquafuel**

As previously announced by Quadrise Fuels International on 11 August 2021, further
tests of bioMSAR™ are being conducted on our Cummins 4-stroke, high-speed diesel
engine generating set to allow accurate performance monitoring, optimisation and
measurements to be made.  We expect the results of this testing at Aquafuel to be
available by the end of September.

Share on:
